How to Install Refrigerator Plumbing | Family Handyman How to Install Refrigerator Plumbing | Family Handyman

How do i hook up water to my fridge, required tools for this project

Add pipe compound to the threads to make it easier to tighten compression joints.

Connect the line to the water line connector on the back of the refrigerator. Required Materials for this Project Avoid last-minute shopping trips by having all your materials ready ahead of time.

Do cruise ship crew hook up

Things You Will Need. You will have to wait hours before you have ice. Avoid over-tightening; you can crush the copper pipe if you apply too much pressure.

How to do dating with boyfriend

Turn on the water supply. The folks at GE Appliances recommend using a vertical pipe, if available.

Online dating email protocol

Tighten the screws on the clamps until the sealing washer swells. However, there is nothing automatic about getting a water line hooked up to the ice maker. Leave the excess water line behind the refrigerator.

Turn the cold water supply valve on beneath the sink.

Attach one end of the copper tubing to the refrigerator's water pipe, using a nut and ferrule. Use pliers to untwist the faucet supply line from the cold water supply valve. Be sure to put a gasket seal between the valve and the T-fitting.

Discard the first two or three batches of ice to flush the system. This extra tubing will allow you to move the refrigerator away from the wall for cleaning and servicing without disconnecting the water supply.

To straighten coiled tubing not the entire rollhave a partner hold the end of the tube flat on the floor, then push the roll against the floor while unrolling to the length you need to go through the cabinets.

Dating pro nulled 2012

Tighten nuts if leaks occur. Connect the tubing to the valve by hand, then turn one extra time with a wrench.

5 best dating sites

If applicable to your refrigerator, run the tubing through the hose clamp to hold it at the preferred angle. Install Plumbing for an Ice Maker A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it.

Tighten the connections slightly if you see a leak.

Dating elements

If you need to drill through floors or walls, check for air ducts, electrical wiring, plumbing or other possible impediments first. Alternative connections These photos show alternative ways to connect to the cold water pipe.

To start, locate the cold water source nearest to the refrigerator—perhaps under the kitchen sink, below the floor, in the wall or even in the ceiling.

Instant message online dating

If tightening the connection does not stop the leak, turn off the water, 100 percent free dating site the connector and add additional thread-seal tape before reconnecting the water line.

It takes patience, but you can hook a water line up to your refrigerator on your own. Make sure you leave extra tubing coiled behind the refrigerator, so you can move the refrigerator when necessary.

Is it just a hookup or more quiz

If you must use a horizontal pipe, place the hole for the valve either on the top or side of the pipe. Let 1 or 2 gallons of water run through the new line to remove the air.